With active electronics, set all controls on the bass to the If you have aīass with passive electronics make sure that the controls O’clock unless you want an overdrive effect. Not turn the volume control in the input section past 1
Hard, is normal and should not raise any concern.
Occasional clip light flashes while playing very If the clip LED flashes excessively, push the button marked To 3 o’clock, slowly bring the Level-A volume up and play. Jack and turn the power switch on, set the master control Using an instrument cable, connect your bass to the Input The Voicing Filter should be turned all the way down to Set all EQ controls and the Boost control to 12 o’clock. Speaker cabinet that can be connected is 8 ohms With the internal cabinetĬonnected, the minimum impedance of an external That will translate to one 8 Ohm cabinet or two 16 Ohm One 4 0hm or two 8 ohm cabinets or One 8 ohm cabinetīackline 250 minimum load impedance is 8 Ohm, That the speaker cabinets power capacity must be equal or Outlet of proper voltage and power rating (see safetyĬonnect your speaker cabinet to the amplifier output Set the power switch to Off and connect the supplied powerĬord from the amplifier AC receptacle to an AC power You a good start for setting up your sound. These directions will take you through the basics and give AllĬontrols have a well defined purpose and are well behaved. Your Backline unit is designed to be simple to operate.
0 kommentar(er)
